Outstanding Selling Point LED PCB Pigtail Kit by BLACKHORSE Tiny Whoop

Description

This is a PCB with LED\’s on it designed by Team TINY WHOOP pilot Blackhorse. This PCB allows you to run a perfect 180?? pigtail with out having to solder the wires at awkward angles. There is one side that you can put the BT2.0 plug into and solder it on to the PCB then solder the wires onto the adjacent pads.?
The BT2.0 plugs can be extremely difficult to unplug at times. The PCB allows for you to grip the plug a little easier than without it making it easier to unplug those tough connections. Having the PCB also makes sure that the pins cannot rotate and can not short out during flight.?
This is one of the easiest ways to add LEDs to your drone without gluing anything or dealing with extra wires.
Included in the Kit:
2x LED PCB boards4x 40mm 22awg wires2x BT2.0 Plugs (Male)
REMEMBER ROUND IS GROUND!
When soldering up these PCB boards to a BT2.0 plug there is a white outline of the BT2.0 plug on the back of the PCB.
Make sure that you line up the BT2.0 so it matches the white outline, otherwise you can short out the LEDs.
I also recommend cutting off the \”half-moons\” from the BT2.0 plug.
Then solder your wires to the remaining pads on the PCB and, viola, you got an epic Blackhorse LED pigtail!!?
REMEMBER ROUND IS GROUND!